DELFINO DL Power Harrow 30-120hp

Introduction

DELFINO DL Power Harrow 30-120hp

The DELFINO DL Power Harrow has been designed for smaller farms and cultivation in specialised areas such as vineyards, amenity and orchards where the width of the machine is very important.

As most of the tractors used in these areas are low horse power, the DELFINO DL is relatively light, plus the specially designed tines allow the soil to be broken up with as little as 30hp on the smaller machines.

All in all the DELFINO DL is a narrow low horse power machine packed with big features similar to those seen on the full range of Maschio Rigid Power Harrows.

Main Features:

  • Cat I/II
  • 6 Spline PTO Shaft With Slip Clutch
  • Mechanical Adjustment Rear Roller
  • Single Speed 540 rpm Gearbox Giving 290rpm rotor speed
  • Parallel Side Deflectors

Features

Gearbox

The DELFINO DL Power Harrow comes with a strong single speed gearbox with 540rpm input giving 290/352*rpm rotor revs.

*Only on 2.3m and 2.5m models

 

PTO shaft

The DELFINO DL comes with a standard slip clutch PTO shaft (1" 3/8 6 spline tractor side yoke).

Linkage mounting

The 1.3m and 1.5m models come as standard with Cat I 3 point hitches, the 1.8m to 2.5m models come as standard with Cat II 3 point hitches.

Depth control

The working depth of the rotors is controlled by a clever pin system which gives you a large range of depth adjustment.

Number of rotors

25cm spacing between the rotors give Maschio Power Harrows more rotors than many other power harrows on the market today, it also lowers the horse power requirement and most importantly leaves a finer tilth.

Timing of rotors

The tine rotors are all positioned at different angles which allow the power harrow to gradually dig into the soil reducing the vibration transmitted to the tractor and reducing peak loads on the driveline resulting in smoother operation and less fuel consumption.

Bolt on tines

The DELFINO DL Power Harrow utilises bolt on, cost effective, specially designed tines.

Tine length is 28cm, thickness 12mm and are made from specially tempered Swedish boron steel.   

Rear roller

The POWER HARROW rollers adapt the machines for different types of soil and different requirements of seed bed preparation. Two types are available on the DELFINO DL- cage roller and packer roller.

Cage Roller - Ø370mm & Ø450mm

Works well on medium soil types and in low moisture conditions creating a good seed bed.

Packer Roller - Ø450mm & Ø500mm

The toothed Packer Roller works well breaking up any surface clods further and at the same leaving an excellent finish, ready for seeding. This roller also comes standard with tungsten coated scrapers.

Rear Roller Bearings

Strength is designed in to the build of each type of roller and the end bearings are protected by their casings whilst grease nipples are positioned out of harm's way.

Levelling Bar

The levelling bars on all models above the DL are mounted on the rear roller, this ensures that the levelling bar does not have to be altered every time the power harrow is adjusted for depth. The adjustment of the levelling bar allows the operator to ensure an even 'bed' of soil is presented to the rear roller for consolidation giving a consistent finish behind the power harrow. The levelling bar can also be used to keep soil, particularly clods, in the rotor area so that it is broken down to a finer particle size before passing underneath the bar and roller.

Tungsten Scrapers

 

Adjustable 'Long Life' Tungsten scrapers are fitted to all packer rollers and rubber rollers, they are positioned low, close to the soil at the rear of the roller ensuring soil does not build up into large clumps before being cleaned off.

Tines and blades

All Maschio tines are produced in Italy by Maschio and are made from high quality Boron tempered steel to provide reliability during work and long lasting performance. They are made on a robotic production line to guarantee that from the first to the last they are all of the finest quality.

 

To assure you of the quality of the Maschio tines, Maschio guarantee the tines for their life…. “So if you break one we replace it!” all completely free of charge.

Point options include:

Bolt on tines

Rotor Design

Pressed spline

The rotor splines are pressed into the shaft not machined, resulting in much stronger teeth and a more robust rotor shaft capable of transmitting higher torque.

50mm rotor

The 50mm rotor shaft gives added strength to the drive-line ensuring years of trouble free operation.

Labyrinth seal

Maschio Power Harrows feature ‘heavy duty’ Labyrinth seals that prevent water and soil penetrating the rotor and gearbox, this also prevent oil escaping even after many seasons of use.

The Labyrinth seal guarantees a perfect seal allowing both bearings to be maintenance-free.

Stress distribution

The Maschio rotor system has a long shaft and reinforced bearings that are spaced as far apart as possible to cope with the twisting force and torque applied to the rotor.

Hardened gears

Hardened gears submerged in oil transfer the power from the drive-line to the rotor tines.

Easy access bearings

Each rotor has a separate cover which allows the bearings to be checked or changed without the need of completely removing the whole transmission trough cover.

Models

DELFINO DL Power Harrow 30-120hp

Models

Delfino DL - Standard Equipment

1300

Single speed gearbox with 540 rpm PTO

Rotor revs (rpm): 290

Slip clutch PTO shaft (1" 3/8 6 spline tractor side yoke)

Universal three point hitch cat. I (1.3m - 1.5m) cat II. (1.8m-2.5m)

Off set front hitches

Rear roller with central mechanical adjustment

Versions below 2300 have low gearboxes to match smaller tractors

Side dampened protectors

«CE» safety guards

1500

1800

2000

2300

2500

Technical Specification

DELFINO DL Power Harrow 30-120hp

Delfino DL Power Harrow with Ø370mm Cage Roller

       

Models

HP

Working Width m

Total Width m

Machine Centre 

No. of Tines

Working Depth cm

Weight kg

Shaft Diameter mm

PTO/RPM

cm <-->cm

1300

30/100

1.3

1.36

65<-->65

10

28

441

50

540/290

1500

35/100

1.5

1.6

75<-->75

12

28

516

50

540/290

1800

45/100

1.8

1.85

90<-->90

14

28

574

50

540/290

2000

60/100

2

2.05

100<-->100

16

28

640

50

540/290

                   
                   

Delfino DL Power Harrow with Ø450mm Packer Roller

       

Models

HP

Working Width m

Total Width m

Machine Centre 

No. of Tines

Working Depth cm

Weight kg

Shaft Diameter mm

PTO/RPM

cm <-->cm

1300

30/100

1.3

1.35

65<-->65

10

28

561

50

540/290

1500

35/100

1.5

1.55

75<-->75

12

28

636

50

540/290

1800

45/100

1.8

1.85

90<-->90

14

28

694

50

540/290

2000

60/100

2

2.05

100<-->100

16

28

770

50

540/290

                   
                   

Delfino DL SUPER Power Harrow with Ø450mm Cage Roller

     

Models

HP

Working Width m

Total Width m

Machine Centre 

No. of Tines

Working Depth cm

Weight kg

Shaft Diameter mm

PTO/RPM

cm <-->cm

2300

65/120

2.3

2.34

115<-->115

18

28

758

50

540/352

2500

70/120

2.5

2.59

125<-->125

20

28

818

50

540/352

                   
                   

Delfino DL SUPER Power Harrow with Ø500mm Packer Roller

     

Models

HP

Working Width m

Total Width m

Machine Centre 

No. of Tines

Working Depth cm

Weight kg

Shaft Diameter mm

PTO/RPM

cm <-->cm

2300

65/120

2.3

2.34

115<-->115

18

28

927

50

540/352

2500

70/120

2.5

2.59

125<-->125

20

28

1008

50

540/352

Options & Accessories

Options & Accessories

Delfino DL Power Harrow - OPTIONAL EXTRAS

Model No.

Description

11M99515609

Leveling bar 1.5m (fitted to Power Harrow)

11M99518609

Leveling bar 1.8m (fitted to Power Harrow)

11M99520609

Leveling bar 2m (fitted to Power Harrow)

11M99523491

Leveling bar 2.3m (fitted to Power Harrow)

11M99525491

Leveling bar 2.5m (fitted to Power Harrow)

11M95512415

Pair of track erradicators with pin adjustment and safety shear bolt

11M99512416

Pair of track erradicators with pin adjustment and safety spring reset

 

Pricing

Maschio Gaspardo January 2017 Price List

To download the MASCHIO GASPARDO product price list click the image above

To download and view our Product Price List you will need the free Adobe Reader
If you don't already have this Click Here to download the Adobe Reader

Downloads

Gallery

Would you like some more information?