BUFALO Flail Mower 100hp - 200hp

Maschio Bufalo Flail Mowers are heavy duty front and rear flail mowers suitable for tractors from 100 to 200 hp and are typically used for professional agricultural and forestry applications.

The Bufalo Flail Mower is suitable for cutting grass, crop residues, cornstalks and shredding branches or twigs. It can be used as a front or rear mounted machine.

The Bufalo uses a self contained gearbox with an input speed of 1000rpm, the gearbox has a 6 spline output shaft on each side allowing the Bufalo to be used as a front or rear mounted flail mower.

The Bufalo Flail Mower is supplied as standard with category II three point hitches to connect to the tractor. The Bufalo has a second category II three point hitch that allows it to be either a front or rear mounted machine.

The Bufalo Flail Mower utilises 5 toothed transmission drive belts to transfer power to the rotor, the toothed drive belts allow slip proof engagement preventing power from the transmission being reduced due to heavy loads or general wear.

The Bufalo Flail Mower comes standard with hammer flails or fish tail flails as an option, the self sharpening hammer flail leaves a clean and level cut and lifts and mulches while cutting, whereas the fish tail flail is used for cutting dense tougher material. The hammers and blades bolt onto an electronically balanced rotor that minimises machine vibration and stress on the bearings.  

The Bufalo Flail Mower comes as standard with double counter blades, an internal lower toothed counter blade and one upper counter blade that ensure that the discharged material is mulched into fine pieces. The upper counter blade enables the Bufalo to produce a finer mulch of harder coarser materials.

The Bufalo Flail Mower has an external rear roller position which unloads material in front of the self cleaning roller, the roller scraper can be manually adjusted if required to suit different working conditions, it presses down the crop residue speeding up break down.

Front chains and rubber guards allow material to enter the cutting chamber but prevent pieces from being thrown out at high speed.

The Bufalo Flail Mower comes as standard with hydraulically adjusted offset. It utilises a hydraulic system to allow the 3 point linkage frame to slide along a front bar to select the offset in either a left or right direction.

A pair of hard wearing protective skids prevent wear to the machine and allow the operator to adjust the cutting length.

The Bufalo Flail Mower uses barrel roller bearings, each bearing has a double rail consisting of two rows of spherical or barrel bearings to cope with heavy workloads. All bearings used in Maschio Flail Mowers are produced by SKF.

Main Advantages:

Long Life (Up to 30% longer life than traditional taper roller bearings) 

High Load Capacity (Shock resistance) 

Easy Maintenance (One of Maschio's main philosophies)

The double skin frame re-enforces the main structure of the machine and also protects the external skin from wear and damage from debris inside the flail mower during work.

Bufalo Models: 2.5m 250 (100-200HP), 2.8m 280 (120-200HP), 3.1m 300 (140-200HP)

Standard Equipment: 

• Double front/rear Cat II/III 3 point hitches
• Hydraulic Offset
• 6 Spline PTO
• Single Speed 1000 rpm Gearbox With Freewheel
• Transmission Belts With External Adjustment
• Hammer Flails
• Double Counter Blade
• Front Chain And Rubber Guard
• Height Adjustable Rear Roller
• Front Or Rear Mounted
• Pair Of Side Skids
• Double Skin Frame