GIRAFFA XXL - Heavy Duty Offset Flail Mower 120-200hp

The Giraffa XXL Flail Mower, previously known as the Giraffona, is the heavy duty offset model, designed for medium sized agricultural tractors from 120 to 200hp and is typically used for amenity and agricultural applications.

The Giraffa XXL Flail Mower is suitable for cutting grass, road side & hedgerow maintenance and shredding branches or twigs.

Main Features

• Cat II/III
• Hydraulic Horizontal offset and tilt
• 6 Spline PTO
• Single Speed 540 rpm Gearbox With Freewheel
• Transmission Belts With External Adjustment
• Hammer Flails
• Toothed Lower Counter Blade
• Steel Front Safety Flaps
• Height Adjustable Rear Roller
• Pair Of Side Skids
• Break Back Protection
• Left & Right hand offset models

The Obstruction Safety Device on the Giraffa XXL Offset Flail Mower protects the machine from damage when hitting immoveable objects during work, by utilising a three spring absorption unit that compresses and allows the Flail Mower to retract and move around the obstacle then return back to its set working position. A steel front buffer bar protects both the machine and obstacle during collisions.

The Giraffa XXL uses a category II or III three point hitches to connect to the tractor depending on the size of the model.

The Giraffa XXL Flail Mower utilises 5 toothed transmission drive belts to transfer power to the rotor, the toothed drive belts allow slip proof engagement preventing power from the transmission being reduced due to heavy loads or general wear.

The Giraffa XXL Flail Mower comes standard with hammer flails and as an option with fish tail flails, the self sharpening hammer flail leaves a clean and level cut and lifts and mulches while cutting. The fish tail flail is used for cutting dense tougher material. The hammers and blades bolt onto the rotor which is electronically balanced to minimise machine vibration and stresses on the bearings.

The Giraffa XXL Offset Flail Mower comes as standard with double counter blades, an internal lower toothed counter blade and one upper counter blade that ensure that the discharged material is mulched into fine pieces. Upper counter blades enable the Giraffona to produce a finer mulch of harder coarser materials.

The internal position unloads the material behind the roller and is recommended for grass cutting. As a rule the roller scraper isn't required for the internal position as the spinning flails on the machine automatically carry out this process.

Steel front safety flaps allow material to enter the cutting chamber but prevent pieces from being thrown out at high speed.

The Giraffa XXL Flail Mower comes as standard with hydraulically adjustable side and incline offset. It utilises a hydraulic system to allow the machine to work either directly behind the tractor or to the side enabling the user to reach far beyond the tractor and the ability to work on vertical or steep sloping surfaces. Comes in both left or right hand models.

A pair of hard wearing protective skids prevent wear to the machine and allow the operator to adjust the cutting length.

The flail head on the Giraffa XXL is fully floating allowing it to follow the contours of the ground.

The Giraffa XXL Flail Mower uses barrel roller bearings, each bearing has a double rail consisting of two rows of spherical or barrel bearings to cope with heavy workloads. All bearings used in Maschio Flail Mowers are produced by SKF.

Main Advantages:

Long Life (Up to 30% longer life than traditional taper roller bearings) 

High Load Capacity (shock resistance) 

Easy Maintenance (One of Maschio's main philosophies)