C Type Rotary Cultivator 60-130hp

“C” Type Maschio Rotary Cultivators are designed for use on small to medium sized agricultural tractors from 60 to 130hp and are typically used for horticultural and agricultural work.

Multi speed PTO gearbox running at 540/1000 rpm. At 540rpm 4 speed settings give a choice of 175, 214, 262 & 143 rotor rpm, at 1000 PTO rpm two speed settings of 324 & 356 are achivable.

PTO shaft with slip clutch protection, 1” 3/8, 6 spline tractor side yoke.

Heavy duty gear drive running in a sealed oil bath to give constant lubrication during work.

Universal CAT II three point swinging hitches allow the machine to follow the contours on undulating ground.

CE Safety guards as standard.

To prevent the rotary cultivator from rolling over when the machine is being detaching from the tractor, the safety pin can be placed in the locked position on the pressure rod which is connected to the rear levelling bonnet.

The new Duo-cone sealing system guarantees reliability without the need for maintenance.  You can achieve at least 50% longer life from the Duo-cone system when compared standard systems in the most demanding working environments.

The sealing system is completely waterproof or “amphibious” allowing the rotor and bearing to run in its own oil supply, this allows the rotor to work and be reliable in the most dustiest environments or even work immersed in water and yet the seals will still prevent water and dust ingress into the rotor and hubs.

The rotor is supported by oversized SKF roller bearings.

The levelling bonnet comes as standard complete with a sprung mechanical rod that puts constant downward pressure on the bonnet and acts as a shock absorber protecting the bonnet from damage, whist working in stony conditions.

The C type Rotary Cultivator has 6 blades per flange ensuring a fine tilth is produced.

A protective skid on either side of the machine controls the working depth and protects the main transmission cover from wear.

The ROTARY CULITVATOR rollers adapt the machines for different types of soil and different requirements of seed bed preparation. Two types are available on the C TYPE - cage roller and packer roller.

Cage Roller - Ø450mm

Works well on medium soil types and in low moisture conditions creating a good seed bed.

Packer Roller - Ø450mm 

The toothed Packer Roller works well breaking up any surface clods further and at the same leaving an excellent finish, ready for seeding. This roller also comes standard with tungsten coated scrapers.

Rear Roller Bearings

Strength is designed in to the build of each type of roller and the end bearings are protected by their casings whilst grease nipples are positioned out of harm's way.

Tungsten Scrapers

Adjustable 'Long Life' Tungsten scrapers are fitted to all packer rollers and rubber rollers, they are positioned low, close to the soil at the rear of the roller ensuring soil does not build up into large clumps before being cleaned off.

C Type Models: 2.1m 205 (60-130HP), 2.35m 230 (70-130HP), 2.6m 250 (80-130HP), 2.85 280 (85-130HP), 3.1m 300 (100-130HP)

Standard Equipment:

• Cat II
• 6 Spline PTO Shaft With Slip Clutch
• 540 rpm Gearbox gives 143, 175, 214 & 262 rpm rotor speeds
• 1000 rpm Gearbox gives 324 & 356 rpm rotor speeds
• Side Gear Drive Immersed In Oil
• 6 blades Per Flange
• Bonnet Spring Adjusters
• Skids, Cage Roller Or Packer Roller for Depth Control